RE: [squid-users] WCCPv2 current instructions?

tor 2006-09-21 klockan 17:07 -0600 skrev Shaun Skillin (home):
> I see the logic here, but what values should be used - do you have
> experience with this problem? I would think to use 1460 for each one.

It's hard to say without knowing exacly where the problem is. I'd
suggest you start with a packet capture to figure out where the traffic
gets stuck, both of the traffic at the proxy and at the client.

> Also, all my devices are on the same network, and it seemd to want an IP
> address instead of "eth0" for a gateway. Any ideas? Thanks!!

Then use dev eth0 instead of via ip.of.gateway.

Regards
Henrik